🚗 Enhance Braking Efficiency with Tekonsha 3035-P Brake Control Wiring Adapter for Ford Review

This 3035-P should not fit the female adapter in my 2018 Land Rover Discovery. As it is not listed for the Rover I bought it after comparing photos of the fork. THIS FITS my Rover. Big. TEKONSHA needs to revise their applicability table. Therefore 4 stars. This is a very well made wiring harness and was easy to install.

Perfect match for my 2015 Winnebago Vista Motorhome. Before ordering, I photographed the connector on the motorhome (by the way, the factory connector is on this Ford 22000# chassis at the bottom of the steering column on the left side) and compared it with this connector. PERFECT FIT, PLUG AND PLAY, couldn't be happier.

This pigtail is suitable for Range Rover 2016 Range Rover 2019 Land Rover Defender 2020 Range Rover 2011 Land Rover LR4 2012. If your Land Rover is factory connected then it will simply plugged into a connector already installed under the fairing where the brake pedal is located. Super easy installation. I assume this will work with all recent Land Rover models that are factory wired.

Bought because I installed a Tekonsha Primus brake controller on my 2003 Ford F350 6.0L with a cheap brake controller already installed. After ripping off a cheap controller wiring harness and removing the old controller, this wiring harness was plugged directly into a factory connector behind the dash above the driver's footwell and straight into the Tekonsha brake controller. So easy, it worked the first time. I've read reviews that it "doesn't fit" my truck, but yes, that's for sure.

Bought the P3 and RF just in case the wiring harness didn't work. I unscrewed the two screws that hold the panel near the brake and gas pedals. To be honest, the only thing I managed to do was let me find the dishes. I put my hand behind the brake and it was about 6 inches to the left of the brake pedal. (I'm a woman so I have small hands). I plugged it in and plugged it into the T3 and it turned on immediately. No additional cables are required. I will update this review after I install the…

I bought this Tekonsha P3 electronic brake control harness adapter. Both the brake controller and my truck came with adapters that only needed to be spliced together at the pre-stripped ends. Didn't want to waste time putting them together and the price was very reasonable so I invested. Also, I have a backup in case I ever need it. My only reservation was that I plugged it into the receiver port on the truck when trying to weave it between the hardware on the dash, to the point where I had the

I have a 2005 Fleetwood Southwind motor home with a Ford F53 chassis. I was having a really hard time locating the connector under the dash so I thought I could help someone figure it out. It took me 2 hours to dig up the dashboard and uselessly disassemble it. The connector on all Ford F53 chassis from '99 to now has a connector on the left hand side of the steering column, but it runs between the 3 trunks of the main wiring harness and the rear. behind the air conditioning shaft. The wire…