🚙 Enhance Your Jeep Wrangler's Accessibility with 82215523 Front Grab Handles - Set of 2 Review

After trying a few non-original options, I decided to just go with these original MOPARs. Too bad I just did it from the start and saved myself the hassle of dealing with cheap aftermarket junk. They are well built and work great.

This ensures good OS descriptor placement. Ease of installation. Remove the front to make it faster. I'm not a fan of the actual grip material. I would prefer something softer and more rubbery. You can put it between the roll bar and the door if it interferes with your normal driving.

Easy to install. The nylon webbing tends to fray and the entire grip hangs too low. They can hit their heads, and in rough terrain they will also bounce off the window. The plastic grip is hard and not very comfortable. They just look cheap. Not what you expect for $40.-.

They are made for JL (2018,2019). I have a JK 17 and after rounding the brackets with a hammer and drilling into the cross member they are amazing. Now I need a pair for the back seats. I used to have bad ones from here with sleeves and velcro with a curved placket. I'm so glad I switched to them.

They cost a little more but are bolted to the roll bar in the right places. That makes them nice and tight. They fit the J-Tops bikini under the padded top of my 2-door JL with some work around the bikini straps. Bonus - for me this is the place to hold on to when hand is resting from the lower window.

Looks like a real Mopar. The fronts are easy to assemble by simply removing the liberty panels. For the back panel (not included), the entire top panel must be removed. Seems solid enough but doesn't really help with boarding like I thought and as a driver I don't really use the one on my side like I usually do with other vehicles.🤷🏾‍♂️

Ideal for Gladiator 2020. Instructions are not very helpful. It is best to loosen the hard top so that you can lift it. Then they hook into the cage at the top outside, then they go inside into the screws that are further up. Just sit on the front seats, unclip the top and lift them up a bit so they hook, then use the factory screws to install. Installation 10 minutes, very strong. It looks like something has settled so the screw may need to be tightened later.