🖥️ DustEND G1 Premium PC Case/Fan Dust Filter Material - Black, 950 x 155 x 1 mm Review

Adhesion is good on the adhesive side, but there is also adhesive residue on the dust side, so dust remains after direct contact with vacuuming the net. While it still looks dusty, the remaining layer of dust shouldn't cause significant airflow resistance. Apart from that, by just covering the air intakes, I was able to fit a 200mm fan, an 18x26cm fan hole on the side of my PC case and 2x14x14cm fan holes and under the PSU on the bottom of the case cover. In general, "dusty appearance" does not

I bought a Coolmaster case from a friend. It was missing most of the front of the hull covering it. I bought this along with DustEND G1 PC Case/Fan Dust Cover to create 2 layers of hole protection and also allow for airflow. So far it looks like a separate case and doesn't let dust through. Please note that the product itself is semi-sticky but not super strong. I ended up using a black electric faucet to hold both products in place.

It's ok I think. This will likely be a secondary or outer layer for larger things, if anything. I had this on an old PC case and it still let through a decent amount of dirt and dust. Of course it was a lot slower, so I think he did his job well enough. The downside is that there are almost no air restrictions, but you have to accept it for what it's worth. But it also caught a lot. There's almost no sticky residue, and I had to use velcro, which was handy but annoying at the same time…