Review on 💡 Eliminate LED Turn Signal Hyper Flash with LivTee 4Pcs 50W 6ohm Load Resistors! by David Diaz

I have a pair of LED taillights that I've been using since April and in July they suddenly caused a Hyperflash on my 2007 Jeep Wrangler. Tested with my stock headlights to confirm the taillights were the problem. After checking several YouTube videos, I found that they could solve my problem. I picked up some 1x1 aluminum corners from Lowe's as research has shown that they cannot be attached directly to plastic as they get so hot. There are no instructions so do your homework, in my case I needed my yellow and black wires. I used my own T-connectors, not the ones supplied, and there is no positive or negative end on the resistor to worry about. Attached the resistor to the outboard end of the bracket using a couple of screws I had around the house and my handy clear Gorilla Glue to attach the bracket to the side of my taillight (I double checked my placement wouldn't get in the way ). before pasting it when using the command line). Not sure about durability yet as it's only been installed for a week, but it solved my problem, no more hyperflash. Brightness also needs a problem, so I can't consider it either. I will check if my mount gets hot and my light melts a few days after my trip necessitating the use of a brake light and will update my review if necessary.