Review on 📱 SPARIN 2 Pack Screen Protector for Microsoft Surface Go 3/2/2021/2020 - 10.5 Inch High Responsive Tempered Glass by Romas Pennington

This screen arrived quickly and was actually simpler than the one I fitted to my phone which was a lot more expensive. Tab stops are key. First watch the video on YouTube. Short side shows 2 tabs, I used 3 tabs on the long side. The protection is very, very slippery and I didn't have an assistant to hold it while I attached the hinges to the screen. So what I did (before removing the tape) was position it with a small piece of tape in the middle of each short end and attach the tape to the top of the tread first. You can then reattach it and fine-tune it without worrying about damaging the included hinges. Press these adhesive strips against the edge of the Surface Go and double check the alignment. If necessary, adjust to perfect condition. THEN attach 3 loops along the long side. With these loops folded back and attached to the protector, you can remove the pieces of tape and start cleaning. Important: Make sure there is no slack in the loop when folded onto the protector. My house has hot air that blows a lot of dust. I turned the thermostat off (or turned it up if you have AC) to keep the system from kicking in and kicking up dust in the middle of my setup. I also wiped down the surface I was working on, washed and dried my hands with a microfiber washcloth. I used a wet swab, then a dry swab, and then an adhesive strip. I removed the film smoothly and quickly, trying not to disrupt the airflow. (Don't let the sticky side touch anything after the film peels off!) I closed the hinge and it immediately started sticking from the hinge side to the screen until it snapped into place. No speck of dust or bubbles, just perfect alignment! Love it!