Review on Suspension Attaching Holder Compatible Microphone by Owen Blanco

I was so excited when I got the wall mount that I immediately started just marking and drilling To discover this: 1) the hole the suspension arm was supposed to fit in was too small (could fit it in, but not very far - and yes, I completely removed the silver screw that was supposed to tighten the fit) for my innoGear arm.2) supplied screws and 'anchors' don't really help much to hold the thing to the wall. On my first attempt to adjust the wishbone, it just slipped off the wall. To solve this problem, so I literally pounded on the suspension arm until I was sure it could take the weight of my mic, unfortunately it doesn't rotate left or right because it's too tight, but I think it does, anyway n the control arm sits tight. As for the anchors, I replaced them and the screws with what I had on hand - far from pretty, but at least I can't accidentally pry them off the wall anymore. For the price I don't think I should have these problems. I seem to be working. but not quite as expected. Would I buy again? Probably no.