Review on VGEBY Adjustable Bearing Remover Straight by Brian Kumar

Needed something to remove the timing belt pulley from the 8mm brushless shaft motor for my electric skateboard. It worked but I had to make an extra shaft to slide it through. I used a 5/16 cut screw. This is because the tip is short and tapered. This is not the product's fault as I used it for something else. However, I have 2 problems: the wings that stick to the ground are not very long so they don't stick too much and slide off. I solved this by using a C-clamp to connect them together so they don't separate as the two included side screws didn't help. In general, it works, but requires some ingenuity