I like the size because it allows for faster build plate alignment. If it's on the plate and starts to heat up, the glue will soften too soon and won't curl well. Much worse than the cheap Lowes blue masking tape. BUT what is good is the texture and adhesion for your prints. I've had excellent adhesion with PLA, ABS and PETG, in fact PETG was so good that even with a wire brush and water I couldn't remove half the tape from the bottom of my print. Good thing it was a proof of something. I found that it would soon lift the pressure and peel off the build plate as the adhesive escapes and not the pressure from the tape. So now I use special clips to make sure it stays on the sides, called binding clips :). No more problems with the tape other than sticking well to prints. Which leads to the last negative I guess if you will. The cheap blue tape I usually use can usually be reused more than once. I didn't find that to be the case with this tape as it lagged behind the build plate and the heat caused wrinkles that were never smoothed out well enough. In my previous use I've used this from 50 to 100C and the band curvature starts at 50. My next try with this might be to try without heat for PLA or PETG if I dare to use it with that again.
10Mm X 11Mm Black Plastic Open Type Cable Wire Carrier Drag Chain Towline R18 For 3D Printer And CNC Machines - 1 Meter Length
7 Review
BIGTREETECH TFT35 V3.0.1 Graphic Smart Display Controller Board For 3D Printer Ramps 1.4 RepRap 3D Printer Can Select Two Work Modes
13 Review
Befenybay 2020 Upgrade: X-Axis Synchronous Belt Tensioner For Creality Ender-3/Ender3 Pro/Ender3 V2/CR-10/CR-10 V2/CR-10 V3/CR-20 Pro –Straighten And Stretch For Enhanced Performance
50 Review
Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards
19 Review
Economic Ender 3D Printer DIY Kit With Resume Printing Function, Large Printable Area Of 220X220X250MM By Creality 3D
18 Review
UV Curing Standard Photopolymer Printer by IFUN
5 Review
🔵 IFUN 3D Rapid Resin - Low Odor Photopolymer Resin for 405nm LCD 3D Printer - Fast Curing, Standard Rigid Formula - Sky Blue, 500g
5 Review
🖨️ ANYCUBIC Assembled Innovation Off Line Printing: Streamline Your Printing Process with Cutting-Edge Technology
5 Review