I've been a design engineer with a master's degree for 37 years. The design of these inserts is terrible. It's a waste of time. If your cap screw is now being pulled out, only drill a hole with the large diameter of the screw that was pulled out. This leaves a stressed and pliable metal in the wall of the hole. Then you will cut it with the same thread? So now you've moved the problem hole to the side by about .050" and have the same pitch and thread depth. Only now it's made of weakened aluminum. And you expect a different result? Definition of stupidity.
Complete Ford 4.6L/5.4L/6.8L 3V Engines Repair Tools Set - Valve Spring Compressor, Crankshaft Positioning Tool, Cam Phaser Holding Tool, Timing Chain Locking Wedge with Crankshaft Pulley Bolt
10 Review
🔧 Honda Valve Adjusting Wrench 10mm by Powerbuilt
9 Review
🔧 GearWrench Universal Pulley Holder - Versatile 15-Inch Tool for Hassle-Free Repair
9 Review
💪 Lisle 39000 Pulley Puller: The Ultimate Tool for Convenient Pulley Removal
9 Review
Bit and socket set Stels Tool set, 1/2", 1/4", CrV, plastic case 94 pcs, Stels, 94 pcs, black
46 Review
Xiaomi Mijia Ratchet Screwdriver 16 in 1 Screwdriver with Interchangeable Bits, 10 pcs, Black
22 Review
Rechargeable screwdriver OA-3,6F (433.0.2.00), 3.6 V, 1.3 Ah Li-ion, blister
46 Review
Tool set Ombra OMT82S12, 82 pcs, brown
22 Review