Review on EPAX NFEP Resin Printer - Enhanced Printing Capability, 295mm x 210mm Build Size by Tyler Kota

When I heard that this nFEP would make my printing better and easier I jumped on board and ordered. I print on Anycubic Photon Mono X and have had great success with original film. . Despite being new and inexperienced, I managed to scratch the film and had to replace it. Enter nFEP. I was thrilled when it arrived despite the negative reviews. I opened the package and it came out fine. I think there should be a protective film on nFEP. My sticker wasn't attached directly to the nFEP, but there was a paper ring around it to which the sticker was attached. I noticed a few small scratches and a few micro scratches. I didn't think anything of it. I installed it on my vat, tuned it to the recommended 310 hertz, thoroughly cleaned all my parts, leveled the platform, shook my ELEGOO ABS-like resin very well, filled the vat and set about making some mini maps from The Lost Kingdom to print . After the printing finished I did my usual cleaning and printed something else. I always give the resin in the vat a little shake and stir. The film caught my eye immediately and I thought I had made a mistake with the setting. After cleaning the tank. it has a distinctive blurred line. I thought I did something wrong. Reconfigured, corrected printer settings, cleaned everything again. I printed a few more Lost Kingdom minis and a SECOND line was formed. These are 2 prints and 2 visible lines in the new nFEP. I'm not sure if I got a bad one or they just aren't good. However, I probably won't buy it again.