Review on Logitech G300s Optical Gaming Mouse with 9 Programmable Buttons and Onboard Memory – Perfect for Ambidextrous Gamers by Kenta Kato ᠌

I believe that this is the most capable mouse that can be purchased for the price that it retails for. Many advantages: Excellent gaming mouse, sensor - ovago never failed, clear clicks, micro candles - omron with a long click resource, the mouse wheel has an optical encoder, which means that dust that has been clogged into the wheel will not interfere with its good work. Additionally, an optical encoder is superior to a mechanical one because in mechanical contact it happens directly, whereas in optical everything happens contactless, the light passes through the wheel with slots and enters the photocell. Great gaming mouse and sensor - In general, the mouse is packed with a lot of really valuable items that cannot in any way be compared to what a4tech has to offer. The sensor has a sensitivity of 2500 dpi, and although I find that playing CS:GO at 500 dpi or lower provides me a pleasant experience overall, it is not feasible to play at a greater sensitivity because the sensor has that setting. There are several distinct kinds of backlighting, each of which emits light in an even manner and is aesthetically pleasant. Even if you plug the mouse onto a different computer, all of your binds will remain intact because the mouse comes equipped with its own memory from the manufacturer. The wire does not have a fabric braid wrapped around it like some other wires do. (may lean over) The wire can be replaced without the need for soldering if you buy a "doner" from Logitech on eBay for the price of two hundred dollars and use it. This is an alternative solution to the problem. This is feasible due to the fact that the wire is not permanently attached to the circuit board in virtually all Logitech mouse; rather, a connector is placed there in its stead. When you look at the photographs of your purported "doner" from the inside, if it has a wire attached to the connector (a white connector on the board from which you may disconnect the wire like it is a plug), then it is OK for you to use it. To replace the wire on the Logitech G300s, you must first remove the upper part of the case by unscrewing the small screws that are located under the tiflon legs. After that, you can proceed to disassemble the device and replace the wire. The next step is to get rid of the old wire by pulling it out of the connector and then getting a new one to take its place. Personally, I changed the wire on my old Logitech G300 by removing it and replacing it with one from a Logitech B100 Black, which I bought for exactly fifty dollars. This was done by removing the old wire and inserting the new wire from the B100 Black. Everything went quite smoothly and according to plan. The mouse has been operational for the past three years at this point. I came to the conclusion that there were no online how-to manuals accessible for this subject matter, therefore I took the decision to describe the process of replacing the wire in a great deal of detail.