Review on 🟨 Enhance Wheel Alignment with SPC Performance 75600 Dual Angle Camber/Toe Shim - Yellow by Josh Chenier

Matrix 2010 Hard Rear Rack Measured by dealer to be a STRONG (and not adjustable) alignment, this shouldn't need any calculation. But the bushing geometry was NOT the same as shown in the instructions. I had to cut off so much of the gasket that I had to use contact adhesive to put the halves together to install them together with the longer screws. But there are no problems with the caliper. The recommended Hunter washers (Delco number) swap the top and bottom numbers, but as per the instructions it doesn't matter if the two numbers match and the installation is vertical AT STREET EQUIPMENT LEVEL. Jacking up the car changes the angle, and I suspect some people struggle with that. Anyway, the orientation is exactly what I wanted now.