🟨 Enhance Wheel Alignment with SPC Performance 75600 Dual Angle Camber/Toe Shim - Yellow Review

I used this product to fix the wheel alignment on my car. Basically the machine was on the leveling post to get the dimensions and specs for the seals. Cut the seal according to the template and check it with the car hub contact surface. marked additional stains that I needed to remove. after that reinstalled and retested alignment and back alignment and it was almost as close in specs to actual predictions. It's just very time consuming, but worth conforming to the specs for. Would definitely…

These gaskets are good but you have to be very careful how you cut them. If you use pliers that are too big, you risk breaking them in half. I had to order a second set due to the same error on my part.

Excellent alignment adjustment method for twist beam axle alignment problems. I've been using shims on VW/Audi for years and it has saved a lot of people a lot of money and time by not having to change axle assemblies. I wish the plastic was stronger and easier to cut/break off if needed as you can easily break the seal in half with little effort.

Matrix 2010 Hard Rear Rack Measured by dealer to be a STRONG (and not adjustable) alignment, this shouldn't need any calculation. But the bushing geometry was NOT the same as shown in the instructions. I had to cut off so much of the gasket that I had to use contact adhesive to put the halves together to install them together with the longer screws. But there are no problems with the caliper. The recommended Hunter washers (Delco number) swap the top and bottom numbers, but as per the…

With so many vehicles now being built without camber adjusters, or with very limited adjusters, these EZShims are a brilliant solution that any ambitious DIYer can pull off. Armed with up-to-date alignment information for your vehicle, EZShims come with simple documentation that allows you to set toe and camber prior to installation on your vehicle. The complexity of the installation depends on the vehicle; The rear axles on my 2004 Lesabre were fairly easy to access and I got the job done in a