Review on 📺 TV Mounting Kit for Steel Studs with Tilt & Low Profile TV Mounts - Includes 4 Snaptoggle Anchors, Steel Drill Bit, and Mounting Hardware by Kenneth Martin

you are perfect. Very high quality. Not the cheap ones from Home Depot or Lowes. Very easy to install if you read the instructions (sometimes it's difficult to measure and find the center of a metal stud and not all studs are the same width). Make sure you hit the center of the bolt, and before you push it, make sure you know the wings will open vertically. You can make adjustments when they're halfway (you can literally feel the victories open up and make corrections when they're not fully vertical). I made a measurement error. When I drilled I missed the center of the stud (a few millimeters wrong. My drill bit hit very close to the left side (the corner of the stud) and misaligned it. I could have corrected the error by simply moving the drill bit ). a bit on the right, but at the time I didn't think it was necessary. It was! When I tried to tighten it it went a little crooked and was still weak. I tried to compensate by over tightening I broke it. All my fault. I called tech support for help and they were fantastic. They immediately sent me another pair. No bureaucracy TVs in less than an hour They are a bit expensive despite the quality and good service. The package contains EVERYTHING you need. All screw sizes for every TV. I rarely recommend a product but this one is great you won no regrets.