Review on 👕 12in x 10ft Black and White HTV Heat Transfer Vinyl - Easy Weed & Cut Iron-On Vinyl for DIY Shirts - 2 Rolls by Kim Sanchez

I'd like to start this review by saying I never write reviews. as usual. But I was so concerned about this product that I had to spend time writing it. If there are a few bad reviews among most of the good ones, I always assume that's the exception and order the product anyway and hope for the best I've done with it and that was a mistake. First, the white was so dusty I couldn't even find a good spot to lay down on my carpet that wasn't stained or stained. It literally looked like the roll had been left open to collect dust and dirt and then rolled up to be mailed to me. Bubbles would form on the mat and I had to try to pick up the crumbs, whatever they were, one at a time, putting the vinyl back on my mat over and over again. The black also had issues with dirt in the vinyl. To be honest it looked like some dirt was put in between the HTV and the plastic backing, because I put it on the mat, I saw the bumps, I went to fix them and I saw them were not on the side facing the mat. It seemed like it was between two layers and there was nothing I could do about it. Second, there were SLOTS in the material. I put a pattern on a vinyl cutter to test, waited the whole time, and when it came out I noticed there was literally a big gap in the vinyl. I was so angry. I then rolled the reel further to make sure it wasn't an isolated incident, the trend continued on the reel. In general, I feel the same as you. I see such a deal on all this vinyl for such a low price and I just have to at least try. But I've found that there's no point in having all that vinyl if none of it is really usable. i will return it