Review on 🚤 High-Performance Marine Fuel Filter Water Separator - 3/8" Barb x 1/4" NPT Fittings - Perfect Replacement for Outboard Motors - Replaces R12T, S3240, 120AT by Jaime Bustamante

Comes assembled with no instructions. Upper canister and lower plastic plunger are fused/glued, seals are completely dry. The canister could not be removed without placing it in a vise and using a 16-inch pipe wrench. Torque is used to remove bent canister walls. The same problem with the bottom plastic bottle. ATTENTION! The lower plastic bulb will dissolve/melt with the gas. ATTENTION: Do not buy! This should be withdrawn from the market unless the bottom plastic is replaced with a non-fusible material that will withstand exposure to fuel. Due to gas leaks and smoke accumulation in the holds, someone may get under the blast. For several days I tested it on the board and didn't install it because it's going to a landfill. If I could rate him, he would have earned a minus (-) 5.