Review on 🌀 Ventline BVC0573-41 Ventadome Replacement Parts - Enhanced Polar White Screen for Improved Ventilation by Joshua Sharma

The distance between the center of the crank hole and the center of the side bolt hole is 2.8" or 2-13/16" or just over 2-3/ 4" is approximately 14" x 14" (exactly 13.5" x 13.5"). There seems to be a major lack of information on RV roof vent parts and grilles. As far as I can tell these are the original roof vent grilles in my 1998 motorhome ventline part number BVA0444-41 or BVA0444-31 or BVA0444-32 (I think they are different color options) Old fixed grilles are hard to find, and even harder to find with exact photos or dimensions These Screen part number seems to replace these old numbers and possibly more Check out my photos, I have the old and new side by side and they are stacked on top of each other so that You can see the crank hole position is perfectly matched. Shipped with no packaging and already without the rectangular knockout of the switch. lt, most likely the seller. I taped a piece of white card to the top of the switch hole, now it's not visible. If you are going to buy a 12v round switch roof fan you will either have to drill a hole in another corner and hope the switch wires are long enough or buy a rectangular snap switch (not expensive). from somewhere like digikey.com and remount it. If you have a 110V fan you're probably out of luck, but I'm not 100% sure as I don't have one. Obviously that white screen isn't the same color as my original, but I don't care. This is the uninterrupted functional equivalent. When the trim ring is installed, everything looks normal. I should also mention that the crank fits and works well with this screen, not perfect but good as the screen gap height is slightly larger than the original. And this screen should have a handle instead of a handle. But it works. This is a very fragile plastic and should be handled with care during installation and any future removal of the detachable screen portion. However, it is no weaker than the original and is actually an OEM part from Ventline, not an aftermarket part. Many van parts appear to be made very cheaply, probably to keep cost and weight to a minimum. Overall this part is fine and I'm glad that after a lot of research and wrong ordering I finally found a modern replacement for my 22 year old roof vent grille.