Header banner
Revain logoHome Page
Jnis Zeile ᠌ photo
1 Level
326 Review
0 Karma

Review on Computer case Deepcool Matrexx 55 MESH black by Jnis Zeile ᠌

Revainrating 5 out of 5

I am one hundred percent satisfied with the purchase, I recommend this product to everyone.

Tired of Thermaltake Core x9, the opportunity to take this case for 2k and a little cashback from the green bank turned up. Everything came together easily and naturally, there are no obvious design flaws in the case, for its money it is very, very good. The basket for hard drives - only for two seats, otherwise it would not be in the lower compartment along with the PSU, but inside the main space of the case and would affect the airflow. I don’t put it in the minuses, who needs a case for six or seven disks - this is not your option. Otherwise, all the same disadvantages inherent in any mid-tower: modern video cards have taken the habit of spitting out hot air not outside the case, but inside, exactly in the direction of the motherboard and glass, from where it all goes up towards the top cover and processor towers. It's not logical at all. Also, the layout of the case will not allow you to install a video card in the lower PCI-E slot, because in such a situation you will block its air intake with a power supply / casing. In general, I am satisfied with the purchase, I consider this case to be the top for my money. Config: Ryzen 2700x 4.2GHz be quiet! DARKROCK PRO 4 Asus DUAL-RTX2070-O8G Asus Prime x-470 Pro HyperX Fury HX434C19FW / 16 x2 (yes, I already know that this RAM is a failure) Samsung EVO 970 256Gb WD20EZRZx2 Cougar CFD120 BLUE x6 (connected with PWM control on a homemade circuit with some kind of mosfet) Thermaltake Smart RGB 700W

Pros
  • Witnesses of the Repairman, rejoice in tempered glass! Lots of space, really big towers fit in. Delivering a case for less money without torsion bars is brilliant, I'll put mine in. Mesh on the front panel, air intake is normal. Cover under bp. Enough space for cables behind the rear wall. There is a lot of space above the motherboard, even with my huge tower, I managed to connect the processor power without mats after installing the motherboard and tower. You can also shove SVO there. Good appearance.
Cons
  • In some places, the quality of execution corresponds to the budget. Flimsy back wall. There are no rubber vibration dampers in the hard sled. Break-out plugs for expansion slots. Dust filters, both top and front - with a grid with a cell diameter of almost a millimeter. Better than nothing, of course, but still. Only one usb 3.0 slot on the front panel, could make two. The basket for two hdds is riveted, does not dismantle and does not move back and forth, but in vain - it would facilitate assembly.