Review on 🔬 Enhanced Precision and Detail: Voxelab Photocuring Assembled Monochrome Anti Aliasing Technology by Ricky Habbani

Failed to load media. It's easy to put together, but the instructions read like they're being run through a google translator. Due to the complexity, previous experience with a 3D printer, especially with regard to alignment, is helpful for the initial setup. The projector display on mine seemed defective in the box as it took a small sliced model and beamed UV light through the entire vat for each layer of the smaller model. This cured about 95% of the resin in the bath, using about half a 500ml bottle of resin in one print test. It is assumed that at this time, the image of each slice is displayed on the LCD touch screen. Instead, each of these images was simply a strip of vertically jumbled lines down the left side of the printable area. These images did not match the sliced layers or even the resulting block of cured resin. Eventually, this first model just stopped at 99% with no warning or error message. Instead, I had to quit the job. This may be because almost all of the resin is already cured/cured, but the printer gives no indication of this. I sent mine back and it will probably be the last resin printer I buy due to this negative experience.