Review on Moza Mini Mi: 3-Axis Smartphone Gimbal with Wireless Charging in Black by Jhalak Jhalak ᠌

A stabilizer without a native application is just a stabilizer and that's fine. By bluetooth, the stub clings only to the native program, and it turns out that even the record button does not work anywhere else. Some pervert decided that the motor that is responsible for tilting the smart back and forth should be on the left. Those. Smart is stuck with the control buttons down. This means that the camera block is at the bottom and periodically (when tilted) captures part of the stabilizer. The smartphone holder is made for some ultra-thin models, there are recesses for buttons in the rubber inserts of the holder, but they are located so deep that there is no sense in them. In a silicone case, I have a 100% clamped power button, without a case 50/50 I wish the handle was more ergonomic. Well, or pre-rubberized would have done. For my money, I would not buy Also, so that the motors do not die, learn how to balance the smartphone in the stabilizer. There are two balances here. Further on the pictures. Stick smart, loosen the screw and move the lever left and right until the smart stops falling on one of the sides. Tighten the screw. Another smart is adjustable in the mounting clips. You stick your smartphone and move it relative to the body of the clamps. The smartphone must rotate around its axis and be fixed in any position without a clear advantage And then the stabilizer will just stabilize. and not to fight with counterweights. Ideally, the smartphone, even with the stabilizer turned off, is level. In this regard, this stub is very well balanced, but I did not have others.