Not quite right. The fillet is too round so it doesn't come out flush. The screws are about a mile away from being usable, making it impossible to align them properly. And there's a bar on the outer edge next to the camera that always prevents it from sitting flush. It's also made out of cheap plastic. If you try to tighten it to avoid it not being flush, the plastic will break. And it just looks cheap. It is flexible and pliable. Unlike the original handle which is nice and ribbed. Basically, they cut the cost by about 30 cents to give you a clean piece of junk. It would be better to get a stand along the camera and modify the OEM grip to accept it. You can use a 3D printer and tape to get a nice clean install. And you can install a much better camera. The camera is the same quality as most $20-$30 cameras. The quality of the pen is less than $30. The cable costs $5 to $10 or less. So expensive junk. Don't buy this.
70mai dash cam pro plus rear cam set A500S-1, 2 cameras, GLONASS, black
49 Review
70mai dash cam midrive D01, black
53 Review
DVR Roadgid Blick GPS WIFI, 2 cameras, black
120 Review
Upgrade Your Car'S Safety With CHORTAU'S 2023 Dash Cam - 1080P FHD, 170° Wide Angle, Night Vision, And More
44 Review
🔍 MANN-FILTER W 811/80: The Optimal Oil Filter for Enhanced Engine Performance
11 Review
🎧 FARO Aviation Headset Converter: Low to High Impedance Adapter for General Aviation (GA) and Military Headsets
9 Review
✈️ Enhance Your Aviation Experience with the David Clark H10-13.4 Aviation Headset
9 Review
🛩️ Stratux ADS-B Dual Band Receiver: Advanced Aviation Weather and Traffic System with WAAS GPS, AHRS, Battery Pack, Suction Mount, Antennas, SDR
9 Review