Review on Camco RV Water Filter Stand - Easy, Upright Storage Solution for Filters- No More Ground Hassles! by King Reeves

They are very heavy (and heavy). that the water joints actually sit on a loop. It would be nice if the loop was a bit smaller and the wider end of the filter housing sat on top of the loop (to avoid tangling with fittings or threads) - otherwise it's strong and heavy - you'll probably need a hammer to hammer it into the Floor. I use this with the Flow Pur RV dual filter. I bought two of these posts and hammered them into the ground side by side with a rubber mallet and then installed the filter block into them. It holds the filter about 3 inches off the ground when the legs are driven fully into the cross brace support. Aesthetically it could look cooler and I still think the rings should match the filter housing, but it's functional and durable. and not expensive.