Review on 📺 Full Motion TV Wall Mount by Mount-It! - Heavy-Duty Dual Arm Articulating Bracket for 50-70 Inches Screens - VESA Compatible up to 800x450mm - 200 Lbs Load Capacity by Jacob Ashman

Should really give 4.5 stars for weak instructions. Wall with 3/16" pilot holes (instructions say use 5/32") but my research have shown that 3/16" works best for yellow pine bolts. I also lubricated four 5/16" screws with beeswax, which is recommended by most pros, and they went in with no problem. - The subwoofer protrudes about 2 inches from the back of the TV. I only tilt the TV forward a few degrees and I'm not sure you can tilt the full 15 degrees without hitting the subwoofer, but that doesn't block the Switch's speaker grille. I used the 5th screw hole from the top on 2 mounting brackets, but you could go higher if subwoofer spacing at a full 15 degrees forward was an issue. One thing the instructions don't mention is that you may need to tighten the 4 screws on the TV mount so it barely turns. The screws on my bracket were too loose and it rotated too easily and didn't hold the TV straight. Also, they must not be tightened when the TV is installed. In short, I am satisfied with the purchase. 04/27/2018: Still works fine. I had to point out that even the pilot hoes listed required quite a bit of torque and after reading the reviews that some of the pull bolts were broken I used stainless steel bolts which I knew were made in the USA. There is a half star deduction for the fact that you need different snap screws than the ones included in the kit.