Review on 🌟 Siser Glitter Heat Transfer Vinyl - Pack of 20 Sheets by Dawn Fischer

I have used this product with my Cricut Explore Air 2 and Easy Press 2. It worked wonderfully! How it works in a nutshell: It is as wide as the cutting mat (approx. 12 inches), so all you have to do is cut it to the length of your cutting mat (12 or 24 inches). Point the outside or shiny side of the iron down at the vinyl (one side is the clear, film-like side and the other is the vinyl itself. You need to cut the vinyl, not the tape side). Make sure you set the machine to "Iron" and press the "Mirror" button too! Do not forget it! I ruined a few good cuts by forgetting that damn button. Cut it off, trim off what you don't want to iron - even tiny bits will iron on, so be careful! But it was so easy to weed, which was so beautiful, and you didn't have to worry about the little things. When you ironed it, I warmed up your item (fabric, shirt, whatever) which I think only helps it stick better. Place the iron on the design in the desired position, face down, shiny side/tape up so your design looks like it has already been transferred, then press or iron lightly. I think I lightly held for about 30 seconds at around 315 degrees Fahrenheit (degrees can be turned off, but google "Cricut Heat Guide" and you'll be golden). Let it cool completely and then remove the tape! My corners didn't stick, peeled off perfectly! Glitter appeared every time, but it was insignificant and in no way spoiled the appearance. Highly Recommended!