Review on 🚥 10-Piece TMH® 3.8" 6-LED Amber Side Marker Lights for Trailers, Trucks, RVs - Rear Side Marker Lights, Trailer LED Marker Lights by Alfonso Tipton

Perfect for my project. All markings checked, everything works. You have 2 wires about 7 1/2 inches long. The marker is just under 4 inches long, 3/4 wide and just under 7/8 thick without the included self-adhesive liner. The seller provided a set of nuts, washers and bolts. I needed a flat marker that would fit snugly on the side of my 1990 30 foot Coachman Travel Master motorhome, which uses corrugated fiberglass panels for structural strength on the sidewalls. These LED lights fit flush into the siding. You look perfect for the project. Now I'm going to wire them to side markers with parking lights and floating on the ground with a turn circle so the marker can signal my intention to change lanes or turn. Also, since these are diode lights, automatic relays must be used if the ground is to be floating between the positive voltage circuit and the turn signal. Connect the left and right sides to a separate relay. When the parking lights are on and the turn signal is on, the parking lights will flash out of phase with the vehicle's front and rear signal lights. When the parking light circuit is disabled, these side LED indicators will flash along with the other direction indicators. In broad daylight, the markings are not as visible. Very good in the evening. Not too bright to distract. UPDATE: 10/14/2019 All lights are working properly. The amber lens has some tarnish, but not to the point where it's a problem.