🚥 10-Piece TMH® 3.8" 6-LED Amber Side Marker Lights for Trailers, Trucks, RVs - Rear Side Marker Lights, Trailer LED Marker Lights Review

Works great at a great price! Also very well sealed and ultra bright! Used under my footpegs to make my own sequential turn signals and so far they have worked great and are very durable. The plastic is thick and well made. At this price I'll be buying more to light up my truck so nobody hits me from behind when I'm using it!

Before installing them on my boat trailer which is often submerged in water, I tested these LEDs to make sure they were indeed waterproof. Yes, they work after and during a freshwater dive. I kept an LED strip under water overnight and tested it the next day. All LEDs light up, no problem. They look good and work well. Will buy again if needed for other uses.

I tested each one after I got them. The reds were amazing and the amber ones were ok too, but when I tested the yellow ones 9 of them were ok and one only lit 3 bulbs not all 6. So now I've shorted out a light. Can't finish work unless everyone is working as they should. Can the company send me a replacement? That's why they got 4 stars as I sent an email but didn't get a reply.

My only complaint is that I wish they had a bigger wire to connect them. Of course, the included cords are more than adequate for the current they draw, but since it's significantly less than a typical trailer light source, it can complicate wiring. They are also anti-glare, but for my purposes that's not a problem. The photo was taken from about 20 feet away in bright sunlight. Time will tell how well they hold up to weather and travel.

Perfect for my project. All markings checked, everything works. You have 2 wires about 7 1/2 inches long. The marker is just under 4 inches long, 3/4 wide and just under 7/8 thick without the included self-adhesive liner. The seller provided a set of nuts, washers and bolts. I needed a flat marker that would fit snugly on the side of my 1990 30 foot Coachman Travel Master motorhome, which uses corrugated fiberglass panels for structural strength on the sidewalls. These LED lights fit flush into