Review on 🔌 Air Hose Quick-Connect Replacement Parts for Sleep Number Bed F-236 & M-236 (3/8 Inch ID Hoses Only) by Don Taniguchi

This set works well and does not leak. The most difficult part is installing an externally threaded nozzle in the mattress chamber. There weren't many instructions, so I added the following basic steps: The main goal is to remove the old nozzle without ripping off the pieces of foam around it. 1) Use regular pliers to gently crush the old nozzle until it breaks. You can crush the foam around the nozzle with pliers to help with this. 2) Use needle nose pliers to gently pry and unscrew the old nozzle pieces from the foam manifold. 3) Clean the old glue and remove the roughness of the surface with a small wire brush 4) Install a new nozzle with glue. I didn't want it to leak so I used a two part epoxy for plastic. https://www.amazon.com/50133-JB-Weld-Plastic-Bonder/dp/B0765B42MG. Some other people said super glue was enough. YMMV.