Holster - Scrap! The belt clip broke after 2 weeks. It was a good idea that the clip could be used as a stand, but the hinge and hinge pin are PLASTIC! The plastic hinge pin does not withstand normal loads, it simply breaks off. The phone case has several design issues that make the phone very frustrating to use. First, the fingerprint reader is basically locked, and only the tip of your finger can be read. If the hole had a conical or beveled edge, then everything would be fine. The second big problem are the buttons. They don't protrude beyond the edges of the case at all. And in the dark you don't notice whether you're standing on the buttons or not. The other big problem with buttons is that they just work. Normally when I hold the phone in my hand, my finger aligns with the power button and a light touch activates the lower power band. This has not happened with any other case or with the phone itself. Another problem is that the outer rubber part of the case tends to detach from the case when you take your phone out of the holster. When this happens, he presses the power button. Buttons also cannot be reused until you reattach the elastic. And at the same time the buttons are often pressed again. It's very bad if the phone rings when it's in a holster. You grab your phone and pull it out of the case, the power button is pressed and the call is rejected. I have never had such problems. The kickstand ring on the back of the phone case works really well. I used it as a stand on a flat surface or held the phone in my hand. I hope it will hold up to frequent use as it is plastic and a bit flimsy.
Sennheiser HD 206 Closed-Back Over Ear Headphones - Discontinued Model
195 Review
π· Q-See QCW3MP16 3.0MP Smart Home Wi-Fi Cube Camera in White
3 Review
BoxWave EverTouch Slimline Stylus Pen: Jet Black, Compatible with Dell Venue Pro
4 Review
ZenPad Z8S ZT582KL / Z8 ZT582KL-VZ1 Case
5 Review