Review on Partsam Double Bullseye Amber LED Trailer Marker Light with 10 Diodes by Josue Zepeda

Check cables before you buy. If you don't run bare wire from the corner, you'll need to change it. There is no recess underneath for the wire nuts and the wire comes out of the corner! I used the #11 drill bit I had on hand to drill at an angle to center between the circuit board and the wall, then carefully widened the hole with a drill and needle nose pliers, loosened the plastic, and die again cables laid. hole towards the center after removing the hot glue around them. This works for me because they go through a 1" hole in the trailer and there is room to slide the wire nuts into the hole. It might not work for you so I give it 3 stars it wastes your time. You could easily modify the die to make it with a socket for connections on the bottom. One pair I had to buy tiny gray wire nuts and wires inside and they fit in the middle part. Also they look nice and bright enough and every led works. I've been using this type for decades and these are the first LEDs with wires that don't come out the back! from the corner.