These look great right away. However, the bezel and base are NOT PERFECTLY THE SAME COLOR. Might be a problem if they are outdoors e.g. B. in the kitchen, but not so much when they are behind the sofa. Also, the front panel screws are the wrong type. They have a flat head and must be countersunk to fit the faceplate AS DESIGNED. This caused the plate to look slightly curved as it was free floating and not forced to align. That and a very slight color deviation almost brought the show to a halt. As I ordered two they could and should have come in one package, instead I received two packages. They came from the same place. If the electrician left a lot of the wires, as they should, and did it here, they should fit without too much force. It was a very tight fit, which may have been one of the reasons for the faceplate misalignment. If you have an old house, and there are a lot of them, with exposed aluminum wire, this is not for you. Copper-plated or just solid. So far the USB is powering my WiFi camera as intended. However, the bottom output is very close to the USB outputs, and when working with most of them there was, as always, one that was slightly larger than the others and didn't come in when the bottom output was busy. iPhone, Samsung and any others I had were close by but could be used without any interference. I haven't checked if they support fast charging yet. Other USB/Duplex connectors may be better, but you'll need to buy one of each to know exactly where the corners were cut.