Review on 👕 High-quality 320LBACR Ironing Board Cover with Vera Foam Memory Foam and Conex Heat Resistant Zone - Perfect for 300LB and 320LB Ironing Boards by Brian Diaz

I already had this particular cover here before buying it, I needed a replacement. The case I received was not similar in quality and design to the real case I had to replace. The cover I received was thin and nowhere near as heavy and thick as the cover I already had, it was also about half an inch smaller all around which made the ironing board difficult to put on. All the fittings were completely different and much cheaper than the cover I already had and it was very poorly sewn. To compound the injury, the top of the cover appeared to be stretched over fabric. I have never seen this on my original cover with careful use. The alligator clips were half the size of the original and didn't include protective caps to protect the circuit board cover on the alligator clips, the rope that secures the cover around. The board was thin and untangled, and the clip/clasp used to secure the rope was half the size of a secure clip. Also, the foam padding on this case was not sandwiched between 3 layers like my current one with a black strap top. , then the foam core, then a third piece of white padding/fabric, that's how my current cover is made to protect the foam core. Only the black cap was present, then very thin black foam. This case was made cheaply. I don't think this was or is a reliable product. In the photos below the black clasp with thick thread is my original case, the white one as you can see is much smaller and cheaper and the thread is much thinner. The rubber band that secures the cover under the board was also flimsy and cheap. Note the original clasps with protective white plastic on the alligator clips to protect the edges of the panel cover fabric. This wasn't on the cover I received and they were a lot smaller and cheaper. Finally, take a look at the cover itself. The white bottom cap is my current cap, underneath the white is the thick black foam or "sandwich" I mentioned above on my original cap, with foam between the top cap and the white underside. The case I received only had a very thin piece of black foam. My original cases weighed about 6.5 pounds and the one I received weighed just over 3 pounds.