Header banner
Revain logoHome Page
Arun Berry photo
Senegal, Dakar
1 Level
745 Review
38 Karma

Review on ๐Ÿ“ฑ Tech Armor HD Clear Film Screen Protector for Apple iPad Air 3 (2019), iPad Pro 10.5 inch [Non-Glass] - Full Coverage, Ultra-Thin, Scratch Resistant - [2-Pack] by Arun Berry

Revainrating 5 out of 5

Ideal. Works great, as easy to use as any.

Perfect. Good quality crystal clear material. You get two in case something goes wrong. I'm not affiliated with the company at any point, but for the screen on this site I think using the hinge method is essential. Otherwise it's too hard, at least for me, to line up. This set comes with stickers but no actual "hinge" installation, but that's fine. I recommend using blue masking tape (or masking tape) as it sticks well but is easy to remove and leaves no residue. Align the protective film first and use spare tape on both sides to hold it in place. I think it's easier to align to the sides than top and bottom. Make sure Side 1 is facing down towards the screen. Check the edges with your fingertips. If it pulls up, it's above that edge and you need to line it up. This will prevent the protective film from lifting after application. Once you have it in place, use more tape to form a loop on the side of the tablet from the home button side. This is the side where the screen protector will peel off. So if you peel off this layer, you won't struggle with the loop, it will help you. Wipe the protective film and screen with a microfiber cloth. I do this in the bathroom with a hot shower as the steam helps reduce dust in the air, but make sure you don't get your iPad wet. Remove the bottom (1) layer. You probably won't be able to line it up perfectly when you pull it off, but that's what a hinge is for. Carefully pry the backing (I use more tape to form the gripping tabs next to the opposite side of the hinge) and then carefully assemble to the hinge. as a guide. So it should fit perfectly. Then just pull off the Velcro and the top layer (2) and you're done. I only had a few air bubbles and they popped out easily (don't forget to wrap the scraper card in a microfiber cloth to avoid scratching the foil). Thanks Tech Armor, another great product!

Pros
  • Always liked
Cons
  • I won't say anything