Review on 🔧 Magnetized Adjustable Hot Gun Desoldering Assistance by Bob Souza

Overall a good product although it could be better. There were already a few problems when unpacking: either the metal plate is slightly bent or the rubber feet are uneven. This makes the entire system unstable. You have to try to bend the board or lay out the legs so that it doesn't rock. - Knurled screw for tool attachment was missing - half of the remaining knurled screws were melted into the thread up to half of the screw, so that it was not possible to screw them in completely. inch It was not possible to just chip off the plastic, it has to be heated and melted. - Several magnetic gooseneck feet and poles came loose, each had to peel off and re-tighten the sticker on the bottom. - The connector between the gooseneck and the clamps is not the best, it often has to be reinstalled. Overall it gets the job done, but for the price I would expect slightly better quality control.