Review on 📷 Enhanced Shield Tempered Glass Screen Protector for Fujifilm X100V Camera by Chris Hossain

First of all, I would like to say that I visited your website, carefully read the instructions and watched the video carefully. I had all the necessary tools on hand: 3M tape, a powerful little flashlight, a credit card, and my own tape. All. I felt confident following the company's detailed instructions. Here are the pitfalls and why their product doesn't work: 1. When leveling the tread and applying masking tape, the underside of the tread in contact with the camera is VERY VERY SLIPPER. It's almost impossible to get perfect alignment, but I've done it over and over again until it seemed like it would fall perfectly. However, in the next critical phase, this did NOT happen. It was slightly off-center, creating a bubble with horizontal edges that didn't flatten out. Their nifty little bubble-handling side avoids the edge of a bubble, which can be the most likely problem. 2. After removing the bottom film, exposing the gel and dropping it, I was surprised to see numerous bubbles under the tread and two edge bubbles that refused to come out. Instructions say to rub with finger and/or credit card. Most of them came out, but my right marginal blister took at least 15 minutes to tremble. My top of the bladder is not moving.3. Don't try to raise the protection after it's finished. They can very well damage the surface of the camera. I've tried removing it with a toothpick and fingernail but to no avail. The end result is just ok. The extreme bubble is at the top, a few tiny bubbles in the middle, and I'm frustrated. In the future I will ONLY buy protective glasses that fit the cameras easily. This product stinks! Just my two cents. I've owned over a dozen high quality cameras and used different brands of screen protectors, but this is by far the worst I've come across.