They are inexpensive for several reasons. First, the wires are short, the ground wire is only 3 inches long, making the nut difficult to install. Second, only 1/8 to 1/4 inch of the wires are stripped, which is insufficient for a proper wire nut installation. You need to continue stripping the wires, which is very difficult as they are short to begin with. Thirdly, the wire jacket is made of a very hard plastic and does not come off easily, a few strands break off easily. Fourth, I've only installed half of them so far and two are flickering. Finally, the instructions don't mention that any type of cable holder should be installed in the cable knockouts, I'm not sure but I don't think it's legal.
🔌 Bussmann MDL 2 Glass Delay Slow Blow
8 Review
🔌 Bussmann GMA 5A Acting Cartridge Listed: Reliable and Efficient Cartridge Fuse for Your Automotive Needs
7 Review
🔌 Enhance Your Electrical Work with Klein Tools 69411 Accessory Adapters
7 Review
⚡ 20 Amp Single Circuit Breaker for Q120
8 Review