5V by Barbara Evans

Name: 📺 MakerFocus 1.5inch OLED Display Module 128x128 Pixel SSD1327 - SPI/I2C Interface, 16-bit Grey Level - for Ar duino/Raspberry/Jetson Nano/STM32 - DC 3.3V / 5V
Item: 📺 MakerFocus 1.5inch OLED Display Module 128x128 Pixel SSD1327 - SPI/I2C Interface, 16-bit Grey Level - for Ar duino/Raspberry/Jetson Nano/STM32 - DC 3.3V / 5V
Rating: 5

October 23, 2022

Note the Vcc/Gnd pin placement

I ordered these OLEDs for use on a TTGO T board but I didn't notice the Vcc/Gnd pins in relation to what is needed are reversed on the T-board. my fault I had to cut the power/ground connections to swap them out. In general, OLED boards are very good. If the contacts are in the right place or it doesn't matter to your project, this is a great prize.

Pros

Same as everything so far

Cons

No form required

New products

Comments (0)

Please, sign in to write a comment

Top products in 🖥️. Single Board Computers

🌐 MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi

2.81

11 Review

LAFVIN Super Starter Kit for Arduino R3 Mega2560 Mega328 Nano with Detailed Tutorial - Compatible with Arduino IDE

4.45

11 Review

🎁 Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)

4.47

11 Review