Review on 🔌 Enhanced RhinoFlex RV Bayonet Elbow Fitting with Versatile 4-in-1 Adapter (39736) by Brandon Woods

I ordered two of these, one as a gift. They were poorly packaged for shipping. They were thrown into a plastic bag suitable for clothing. Not even a bag with a bubble wall. When they should have been in a box with airbags for protection. It took 4 weeks to arrive via USPS. Not Revvan. Even once marked as "lost" in the tracking department. . When they finally arrived they were split into 4 pieces in a bag, none of which were broken. All were ripped from cardboard display "holders" (formerly hung on a hook in the store). The original box holders were torn and torn. Everyone had to be in their own box. NOW DELIVERY ONLY, NOW THE SEWAGE ANGLE. I was disappointed with the design. (1) The rotating part of the 4-hole connector that snaps onto the end of the hose was difficult to turn (rotate). Maybe it's "broken" after some use. The seal inside was flexible and pre-lubricated. (2) The seal on the clear plastic end was too stiff, too hard. It didn't shrink when attached to the orange threaded half. (3) The 4 small pins on it go into 4 slots inside the orange threaded section. It appears to be a design flaw. If it is stuck when fixed, it will be very difficult to loosen, take it off. If the seal is not rotated fully, it will not stay attached and will come loose easily. (4) The orange component is poorly designed. The threads are too thick. Not formed sharp enough to screw into the female. The thread length is too short. Insufficient area exposed to female pipe. (5) If a 6" threaded section is used, there is no clearance above to install the clear elbow and thread the retaining ring onto the end of the hose. It must be above the 6" thread. (6) They boast that the clear bow is "short" to fit the sewer hose storage. That was one of the reasons I ordered them. I did a 4" round tube/storage tube. A transparent knee will do, but NOT the orange rotating part of the collar. Because of the handles on the outside that were used for locking when turning. Now these grips can fit into the corners of the bumper's square tube. I returned them. Check out the Valterra branded version of this component, similar, slightly different. It may work better for you.