Review on 🎮 Enhance Gaming Performance with Beracah LB RB Bumpers Triggers for Xbox One Elite 3.5mm Jack by Stacey Vang

I installed the Xbox Elite Controller, I've had it since it was released but had to replace the right bumper. This purchase included a central silver plastic surrounding the Xbox button and micro USB port. The bumpers are actually one piece for both buttons. Good: - Similar color - Same gauge as OEM, I was hoping for a stronger one so no repeat issues - Didn't break during shipping. Bad: - Difficult to install - Color doesn't match perfectly. I couldn't get the centerpiece they sent to match. I've been watching a youtube video on how to install these things and it's tricky because they don't mention that the bumper has two holes in the middle that MUST be put on the pins above which are on the middle plastic condition. The two parts are connected before installation. And without this factor, the keys will not be pressed. You stay down. It took me 15 minutes to wrestle with the old new centerpiece, I gave up and used my original centerpiece and it snapped into place very easily. That's when I found that my bumper had come loose from the center section, although it seemed perfectly fitted, the bumpers didn't give way when pressed, I had to tighten them. I reinstalled it very carefully with the two connected and not disconnected when installed. Each bumper has curved edges on the outside. They need to be slid into place after there will be a "hard click" as the two pieces (center piece and bumper) are pushed into place and the center piece slides over the Xbox home button. Also pay attention to the green button next to the microphone. USB, nothing really keeps it in place permanently, it's just a plastic pin in a plastic slot. This will void your warranty. Mine expired a few years ago. Installed correctly = works very well. I play competitive first person shooters and this is my melee button so I use it a few times a minute. Need: - Security torx set, maybe like T15 but not sure, just had a set and tried everything until it fit. Just 5 screws of the same size. A pick or similar, because first you'll pry off the sides of the handle. Carefully. You can't do this without breaking something without seeing someone else first, please find a 5 minute YouTube video for a happy ending and good luck!