Review on Xprite Signal Assembly 2007 2018 Wrangler by Thomas Chalecki

These turn signals are amazing. I originally bought their cheaper $35 set and was very disappointed with the brightness so I figured I'd just spend the extra $15 and buy them and I wasn't disappointed. These are super bright. And they look pretty cool if you ask me. The cheaper kit I got wasn't even as bright as the stock bulbs, but they are about 20-30 times brighter than the stock bulbs. I see them edge to edge in my two car garage, they are visible on the floor, they are visible to the ceiling. They are bright. I have a clear lens for maximum brightness. I have a 2016 JKU Sport and have not had to use any resistors. No Hyperflash, no problems yet. plug and play Fitting it into the grille was a little trickier than some people with limited mechanical skills would like, but it wasn't hard to figure out. The easiest way is to remove the grille entirely and lay it face down on a table or workbench, take out the old headlights, figure out which direction you need the bracket for each side, and then insert the brackets into the slots to be installed in the grille Lift the headlights into place. You can watch the tabs fit into the slots on the back of the headlight. Once the tabs are fully seated in the slots, insert and tighten the screw. One had no problems, the other had a bit of a fight with me because the rear bracket didn't fit the slots perfectly, so I swapped them and then they both went in at once. Just be gentle and keep trying until you get it, it's really not that hard. This bracket holds these headlights up much better than a bunch of little plastic tabs like the stock ones. If you're not sure, the store will surely install them for you. Overall I'm very happy with it. 5/5 recommend and will buy again. Will update along the way as they hold up.