Review on 🚘 Enhance Your Chevrolet Cruze with KATUR 2X License Plate Light for Sleek Car Styling and Convenient Trunk Switch Button Assembly by Shawn Welker

Wrong item for all Cruze with rear camera. This particular wiring harness uses a 4 pin connector. Cars with rear view cameras (like mine) use an 8 pin connector. Also, license plate light reflectors use different bulb sockets. The only way to use this harness was to cut the pressure switch off of both harnesses and then plug the new pressure switch into the old harness using low voltage connectors. There are 2 black cables going to the pressure sensor, no matter which one goes to whom. The old switch was buried in a puddle of hard epoxy. It took a lot of chiseling to free him. I covered the new switch with a weatherproof lime coating to keep moisture out. It takes less than 30 minutes with the wiring, a screwdriver, a 7mm socket, a 10mm socket and a plastic tool to pull out the push pins.