Review on 🖥️ 3M Under-Desk Computer Tower CPU Holder: Adjustable Width and Height, Swivels 360⁰, Supports up to 50 lbs, Steel Construction - Black (CS200MB) by Alan Singh

Not bad for the price. My computer is a bit wide and it seemed to lean a bit. Then I realized that the stand has 4 screws to detach it from the rotating top so it can be moved left or right depending on the width of your computer. I moved mine one set of holes to the right and now they sit more evenly. Still not perfectly centered, but definitely more stable. I wish the retaining lever on the left was metal instead of plastic. The top of the lever is the only part that makes contact with the computer, as the lever bends and buckles a bit when you try to push it down. I have a fairly large/heavy computer and it feels rock solid in this rack. I've found it's best to reach back for the side arm locking knob when pulling or pushing the computer along the rail. If you pull or push on the computer itself, this thing will wiggle back and forth all over the place, which I think is a good way to damage it. You should have put a pen on it. I also installed mine further under the table than the instructions say and when fully extended it still sticks out a couple of inches past the front of the table which is all I need. When it's fully reclined, there's enough room to keep the cables from bumping into the wall. I'd suggest taking some serious measurements (taking into account the depth of your computer) before installing if you don't want to be disappointed. There are rubber bumpers on both sides, but none on the bottom.