See photos. The magnet is not strong enough to hold the flexplate in place while printing. , 2021. 10 prints before writing this review. 3M tape: Good. Adhesion of the flexible plate to the print: not impressive. (I had to roughen the surface.) Flexible Plate Removes Pressure: Good. Attraction of the flexible plate to the magnet: Poor. The magnet cannot handle a model with a large base or many supports. Anything that covers more than 50% of the total FEP sheet area. The magnet does not hold tension on the FEP, so the flex sheet flexes, allowing the resin into the gap of the magnet. With resin between the flexplate and magnet, the flexplate slides with each retract, leaving steps and x/y errors. (See my photos) The bars in the first photo should be vertical bars, not smooth curves. The plate shifted in the x/y direction when it was lifted off the FEP. The plate in the second photo shows the flexible plate separating from the magnet and flexing the underside of this print. The magnet cannot hold the flexible sheet in place against the attraction of a large area. Also, the flex plate release tab is too wide for the Elegoo Mars Pro 2 tank. It will scrape the edge when retracting unless you tilt it diagonally. Buyers be careful. Before writing this, I tried adjusting the bottom layer retraction speed and bottom layer exposure time, but the same problems persisted. This product does not have sufficient durability to attach large prints without being pulled off the magnet.
10Mm X 11Mm Black Plastic Open Type Cable Wire Carrier Drag Chain Towline R18 For 3D Printer And CNC Machines - 1 Meter Length
7 Review
Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards
19 Review
Iverntech NEMA 17 Stepper Motor With Integrated 350Mm T8 Lead Screw: The Ultimate Solution For Precise Z Axis Movement In 3D Printing And CNC Machining
6 Review
BIGTREETECH SKR 3 EZ Control Board 32Bit New Upgrade Silent Board Support EZ2209/ EZ5160/ EZ2130 Stepper Driver Compatible TFT Series Touch Screen, DIY For Most FDM 3D Printer (With 5PCS EZ2209)
7 Review
๐จ๏ธ FLASHFORGE Adventurer: Enhanced 3D Printer with Removable Extruders and Monitoring Features
4 Review
๐ต IFUN 3D Rapid Resin - Low Odor Photopolymer Resin for 405nm LCD 3D Printer - Fast Curing, Standard Rigid Formula - Sky Blue, 500g
5 Review
๐จ๏ธ IFUN 3D Printing Liquid Resin: High-Quality Innovative Solution
5 Review
High-Precision And Stable Creality Ender 3 V2 3D Printer With New UI, Silent Mainboard, Effortless Filament Feed-In, XY-Axis Tensioner, Resume Printing, And Large Build Volume Of 220ร220ร250Mm
11 Review