I am using this for a very specific type of LED lighting to dimly light an area and then when the motion sensor is triggered the light will increase VERY slowly brighter in all modes that are set to delay flashing, then fixate long enough for the lights to flash slowly over the course of two minutes. I made the slow whitening scheme separately. Then stay bright for 3 minutes, anytime during the cycle if motion when re-triggered restarts the sequence timer (maintains bright lighting) until motion is detected for the duration of the timer, then turns on out to slowly fade away. This allows the prey to feed at night and not be startled by the lights. And saves energy as the system is charged daily by solar energy. The only reason for 4 and not 5 stars is to determine the decimal settings of the timer. SO.///.Start setup/program mode, switch to the "NX" LED. The rightmost digit sets the multiplier for the "T1" timer 1 = 1x9999 seconds 0 which was factory set allows the timer to run for only 60 seconds, MAXIMUM 9 which IIRC uses to increase the time to 27 hours can!?!? SECOND DIGIT RIGHT Time Multiplier "T2"
REXQualis Comprehensive Starter Kit with Arduino MEGA 2560 & Detailed Tutorial for Arduino IDE Compatibility
11 Review
๐ Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
GeeekPi Raspberry Pi Cluster Case with Cooling Fan and Heatsink for Pi 4 Model B, 3 Model B+ & 3/2 Model B
11 Review
LAFVIN Super Starter Kit for Arduino R3 Mega2560 Mega328 Nano with Detailed Tutorial - Compatible with Arduino IDE
11 Review
Comprehensive 500pcs Laptop Screw Kit Set for ๐ฉ IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
๐ฅ๏ธ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review