Review on 🚗 Enhance Your Tesla Model 3/S/X/Y with EastFly Puddle Lights: Car Logo Projector for Door Courtesy Step Light + LED Interior Accessories by Mufti Carter

Replacement Order. My original order arrived and one of the lightbulbs was broken. Obviously the bulbs were not tested as one of the original bulbs was not connected (as can be seen through the clear plastic). Another original tidiness indicator, showing multiple wires leading to a small circuit board. I recommend that you do not install any lamps in the door until you are sure that both lamps are working. You'll have to pay the devil trying to remove those headlights once they're installed (more below). Other issues. > Headlights do not come with instructions. > You must use the jumpers provided. Jumpers are NOT compatible with Tesla chassis. Well it seems normal but the jumpers are not polarized and will not close together. Tesla connectors are polarized and connect to each other. I used liquid tape (similar to glue) to provide some fixation between the Tesla connector, jumper wire, and this new bulb. > The body of the new bulb is larger than the bulb hole in the door panel. You can slide the light through the door panel and it stays in place perfectly. Capturing the new light, however, is not easy. Using a screwdriver to block the light didn't work for me. Eventually the clear plastic cover fell off and I was able to rotate it 90 degrees and grab the lamp with pliers. Good stuff > These bulbs put out a decent picture and only draw about 150mA at 12V.