Review on Dometic 3309518.003 Brisk Replacement Shroud - Polar White with Gray Band - Reliable and Stylish Protection for your RV Air Conditioner by Bobby Frazier

Firstly, do you have a riveting tool? I also had a very large vise as a third hand. I also needed a cut-off wheel grinder for two different jobs. You will of course need a Phillips screwdriver. Step one. The plastic world must be assembled with rivets. Thought it could be done and shipped for you, I think it would require a bigger box. It warps a bit and requires a lot of profanity to make it work. This product had very poor quality rivets that were broken about halfway and protruded over an inch. This is the first time I've had this type of failure with rivets and it's happened many times, I've used my grinder to cut them off and remove sharp edges. To fit my air conditioner they recommend cutting a few pieces of galvanized steel at an angle. next to the capacitor coils. Finally, you should have rubbing alcohol and a rag to clean the parts you will be gluing the insulation foam to. It comes with shiny new hardware. The two screw holes on the back don't match the longer screws you need to open the holes. I used a drill. Looks good just needs some time compared to a peaceful option.