Review on 🔔 Bell and Gossett 103251 NRF-22 Cast Iron Wet Rotor Circulator Pump by Bell and Gossett by Matt Charlton

Don't call a plumber unless you want his truck to pay for it. Close the main water tap, relieve the pressure by opening the taps. Disconnect the power cord from the pump. Hold a bucket of water under you to collect water in the lines. Use a wrench and socket to loosen the bracket screws. Before removing the pump, look at the water direction arrow. The pumping oscillation is weakened. After removing, open the electrical cover, loosen the cable screws and pull out the power cord. Connect the power cord to the new pump and replace the cover. Attach rubber rings to each end of the pump. Check the pipe connections and use a wire brush to clean any dirt or scale deposits. After cleaning, insert/install the water pump and align the water flow arrow in the correct direction. Note. water flow. Before removing the old pump, you can use a sharp point. Check out the new pump for a quick reference. After double checking that the rubber o-rings/gaskets are properly installed, carefully tighten the screws by hand. Then tighten the bolts and nuts with a wrench. wipe clean Turn on the main water pressure. Then open some hot water taps to start the water flow. stop running Now connect the pump to a power outlet. You will hear and feel a slight hum. Once you feel the water pipes getting warm or hot at the top and bottom, you're done. After 15 minutes you have a pump. Good price and although a Chinese product it works.