Review on 🚚 Daystar Dodge Full Size Truck Polyurethane Bump Stop: Enhance Suspension Performance | Fits 1994-2004 Dodge & 1994-1998 ZJ Grand Cherokee | KU09022BK | Made in USA | Black by Clint Mcloven

Installation is easy if you use the 'work better than hard' approach. All the old fender stuff has come out of the cup. Then clean the rim of the cup. If the cup is damaged, replace the cup, two 13mm screws hold the cup to the GC frame. Then lift the body of the rig off the frame just in front of the rear wheel (I mounted it with the tires installed). (NOTE: You'll need about 3-4 inches of extra clearance from the axle for this. My tires were still on the ground.) Hold a fender in a cup and measure the clearance to the axle tube (I had 7" I did a little lift installed) Cut a 2x4 to this length Now grease the shell and bumper with some liquid soap and water Place the bumper in the shell, place the cut piece of 2x4 on the axle tube and on the underside of the lift raise the jack and slowly lower it stopper and spring 2x4 and all the other stuff you used to raise it up lower the jack go to the other side and repeat easy! Hope this helps some people .