Review on 🖨️ Stainless 3D Printer Filament Extruder by Tom Goodlow

Honestly I didn't buy the extruder pulley for its intended use. It took me two gears to turn the movement to the right of the lathe handle that I do into a left movement (instead of using a left hand threaded rod). Almost all the gears I've found cost over $15 per gear as they were made for expensive RC car models. The 36 teeth of your pulley are so well made that two of them mesh perfectly. The only downside for me is that the total hole is 5mm (I need 8mm) but that's easily overcome. There is a large market for gears of this type (perhaps slightly larger in diameter). There is an untapped market for your gear manufacturer. Your pulley teeth are of excellent quality and cost much less than regular gears on the market. Good luck and have a nice day. Eliezer