I have a truck and the brake light was damaged by what appeared to be an airgun. I put a patch on first as I said it was about 70 degrees and I live in California so there is no humidity. The lens material seemed to stick to the light lens, but later everything around the edge peeled off. I removed the lens and cut out another new piece, but this time I used rubbing alcohol first. After the surface was dry I applied the plaster. Same problem with peeling edges. I took my heat gun (you could probably use a hair dryer) and started heating the plastic wrap (being careful not to melt it). Then I took a thick piece of hard plastic the size of a finishing brush and started pressing down the edges. The heat helped the plastic mold to bend, and the next morning it was nice and dry with a tiny 1/16 inch gap. I filled the gap with clear indoor/outdoor glue and everything looks great this afternoon. I showed my friend the results and we couldn't see the repair until we got really close (2 or 3 feet).
POR-15 Patch - 4 oz White Filler & Seam Sealer for Steel, 🔧 Wood, and Plastics - Ultimate Adhesive to Strengthen Weakened Metal and Patch Holes and Cracks
12 Review
🔴 Permatex 81160 High-Temp Red RTV Silicone Gasket: Reliable 3 oz Solution
9 Review
Clean Sheets CLN-CS100: 100 Disposable Superior Mixing Pad (12x12) for Toughest Jobs - Clear
11 Review
🧽 Vdera SPLAT-AC-3P Splat Orange Auto-Clean Cleaning Putty - 3 oz.: The Ultimate Solution for Easy and Efficient Cleaning
10 Review
ReadySkin Multifunctional nanoSkin RF lifting and rejuvenation device 1 pc.
56 Review
Complete 9-Piece Detailing Brush Set For Ultimate Car Deep Cleaning: Perfect For Cleaning Interior And Exterior, Wheels And Engine Dashboard With Boar Hair And Wire Brushes
12 Review
144-Pack Microfiber Cleaning Cloths - Non-Abrasive, Reusable & Washable (12X16In) | Amazon Basics Blue/White/Yellow
31 Review
Dunlop Winter Maxx WM01 275/35 R21 99T
28 Review