Review on OMOTON Google Pixel 4 XL Screen Protector - 4 Pack Tempered Glass with Alignment Frame, Scratch Resistant, Bubble Free - Compatible with Google Pixel 4XL 2019 Released by Carlos Jass

I ordered a Pixel 4 XL on Black Friday and it took a month to receive it from Google. I've been using tempered glass for a long time. To be honest, most of these defenders are about the same. All are shiny, reflect light and break after a while. I have no problem with these screen protectors cracking as I've cracked screen protectors rather than my phone's screen. If the protective films are torn, they are doing their job. That's why a pack of multiple screen protectors is better as I can replace them as needed. This particular screen protector is acceptable. The mounting frame fits the phone perfectly and the protective film fits perfectly. Applying this protective film is very easy and hassle-free. There were a few bubbles that wouldn't move to the edge, but they all went away after about 10 hours. There was a small bubble in the lower right corner caused by a dust particle, it was my fault. I didn't clean as well as I thought I would. When the screen is on, I don't see that tiny speck. It's good enough for me. This screen protector fits the screen perfectly and is easy to install. Including 4 protective films. There is nothing I can think negatively about this purchase. I have used many glass screen protectors. This is recommended. Note: - When I was writing this review, I picked up my phone and noticed that there was already a hairline next to the dust spot. I probably tried too hard by clicking on the local area to remove this bubble. I will replace this protective film when the tear becomes more visible. This does not affect my rating of this review. After posting this review I'm replacing the screen protector as I have 3 spares. After removing the attached protective film, I found that there was no tear. It was the glue in that area not being as even as it should have been giving the appearance of a line/crack. I should have left it alone. Glad I removed that speck of dust. I have another blister elsewhere but there is no dust and it should be gone in about a day. When that bubble is gone it will be as perfect a setup as it gets. :) Edit 2 As I expected, the bubble disappeared after about 3-4 hours of installation. I have to say that the install took less than 3 minutes the second time including the clean up time. If you need a screen protector for your Pixel 4 XL, this is a really good choice. Edit 3 I just broke the protective film. My steel thermos tipped over and fell onto the edge of the phone. The screen protector did the trick and protected my phone's screen. I took out another protective film and replaced the torn one. Another job for 3 minutes. I can handle the installation. The protective film came off with no problems. If I could give that 6 stars I would.